eSUN 3D Printing Filament storage box + Respool+Refilament for 3D printer

   eBOX is a product that heats, weighs and combines moisture proof and dustproof capabilities to offer a dry storage environment and avoid the influence of moisture on 3D printing filament so that it can maintain its properties. In addition, through the weighing function, users can view the wire margin in real time, greatly facilitating printing.

      Before using the filaments, consumers will be both troubled in putting away the spool. Refilament filaments combined with Respool can perfect tackle this problem. What’s more, the Refilament lined neat, reducing the knot of the filaments; the Respool can be reused to save resources; at the same time, it also saves the transportation costs and reduces the spool’s transportation.The eBOX can be used to heat and dry the filaments at any time, and it also has the function of moisture-proof and dustproof, and the residual condition of the filaments are been monitored.

Refilament + Respool User Guide

I. Loading 

1:  Take out the filament from vacuum bag, roll the filament into spool side A in clockwise. 

   Put the end of filament on the fastener. 

2: Roll spool side B in 1 or 2 circles in clockwise , press the filament tightly .

  Make sure the outlet between spool side A and B are match .  

 3. Pull out the filament tie, loading complete. 

II Dismantle

1 :   Insert the tie from spool side A and mark sure it get though the outlet of side B.

2: Tie the filament , and press tightly. Make sure the blue tie is facing up.

3 : Take off spool side B in anticlockwise , and took off the filament in clockwise.   Dismantle complete.

III  Preserve

Put the filament into vacuum bag, use the hand pump to draw out air inside.